Fudge-Making Mistakes and How to Fix Them (2024)

FAQs

Fudge-Making Mistakes and How to Fix Them? ›

To fix oily, hard or grainy fudge, scoop the fudge back into a pot with about a cup of water. Cook it over low heat until the fudge dissolves. Then bring the fudge back up to the temperature specified in the recipe and follow the remaining steps. The flavor may be slightly diluted, but the texture will be improved.

Options for what you can do with your unset fudge:

OPTION 1) Depending on how runny it is, you can either use it as a frosting for cakes, or a sauce for ice-cream.

The key to creamy, luscious fudge is controlling crystal formation. If the sucrose (table sugar) crystals are small, the fudge will feel creamy and smooth on your tongue. But if the crystals are large, the fudge develops a crumbly, dry, or even coarse texture.

It should form a soft ball that can easily flatten between your fingers. Repeat this test every two minutes, each time using a clean spoon, until the fudge has the desired consistency.

This often happens when the condensed milk and chocolate chip mixture isn't hot enough to start. Everything must be completely melted before it is transferred to the pan to cool. Heat in 30-second bursts in the microwave, stirring well between each to ensure everything is melting evenly.

To fix oily, hard or grainy fudge, scoop the fudge back into a pot with about a cup of water. Cook it over low heat until the fudge dissolves. Then bring the fudge back up to the temperature specified in the recipe and follow the remaining steps. The flavor may be slightly diluted, but the texture will be improved.

If you continue stirring once the mixture is simmering, you are encouraging the development of sugar crystals. While crystallization is the goal if you're making hard candy, crunchy sugar bits can quickly ruin a fudge's silky smooth texture.

Don't stir!

Once the fudge reaches soft-ball stage on the candy thermometer, remove from the heat and let the temperature drop to 110°F. Keep that spoon or spatula out of the pot until this happens. If you stir too early in the process, you'll make the sugar crystals too big and end up with grainy fudge.

While you ultimately want crystals to form, it's important that they don't form too early. The key to successful, nongrainy fudge is in the cooling, not the cooking. The recipe calls for heating the ingredients to the soft-ball stage, or 234° F, then allowing it to cool undisturbed to approximately 110° F.

The fudge is then beaten as this makes the fudge slightly crumbly rather than chewy. Beating the mixture encourages the formation of small sugar crystals, which leads to the crumbly texture. The crystals may not be noticeable in themselves but the fudge mixture will thicken and turn from shiny to matte in appearance.

How long do you let fudge cool before beating? ›

Let cool before beating

After being cooked, the sugar must crystallize again to create fudge. This stage will determine the size of the sugar crystals. The sugar should ideally form small crystals that are barely discernible on the tongue. To achieve this, let the mixture cool for 15 minutes before beating it.

Secondly, the pot's material should allow for good heat distribution hence your top choice should be copper cookware or a pot with a copper core. Copper's exceptional heat conductivity offers unparalleled temperature control, an asset when working with finicky ingredients like sugar.

If the temperature is too low, the fudge will be too soft and sticky, and if it's too high, it will turn into a hard, crumbly mess. The ideal temperature to cook fudge is between 232-234 degrees F (111-112 degrees C).

Don't Substitute One for the Other

Thus, using condensed milk in a recipe that requires evaporated milk will yield an overly sweet dish.

Too cooked

This fudge was cooked to a temperature of 118 °C (244 °F). At this temperature, the sugar is too concentrated and there is not enough water left to form syrup around sugar crystals. The result is hard and brittle fudge.

​Harden the fudge:​ Place your container or tins in the fridge for 2 hours, which is the time it takes for the fudge to set. Once it's hardened, cut the fudge into 12 pieces or remove it from the muffin tins. Store in the fridge or the freezer (if you don't devour it right away).

To fix soft fudge or hard fudge, simply follow these easy steps: Scrape the fudge back into a large saucepan and add 1 1/2 cups of water. Stir the fudge over low heat until it dissolves. Carefully taste the mixture, as the water probably diluted the flavor.

You have one option to make it soft, which is you have to put the fudge pieces in a plastic bag along with the paper towel or a bread slice. Secure the bag and leave it overnight, next day you will get a softened fudge.

If your fudge is soft or runny, it probably didn't come up to a high enough temperature while it was cooking. Put it back into the saucepan and add 1–2 US tbsp (15–30 ml) of 35% fat whipping cream. Stir the fudge as it heats, but only until the sugar in the chocolate is completely melted again.

– The most likely explanation is that your fudge didn't quite reach the full temperature it needed to be. If the mixture only ever reaches 110 or 112 degrees celcius it will always be soft. Our advice would be to buy a candy thermometer and take the guesswork out of the fudge making.